Manualshelf

User manual

ManualsBrandsRIGOL ManualsLaboratory Test EquipmentDigital 100 MHz 2 null 14 null 8 Bit Digital storage (DSO)
251252253254255256257258259260
Chapter 2 Command System RIGOL
DS4000E Programming Guide 2-239
:WAVeform Commands
The :WAVeform commands are used to set the parameters concerning waveform data reading and to read
the waveform data. In different waveform data reading mode (refer to the :WAVeform:MODE command),
the definition of each parameter is different. The definitions of the parameters in NORMAL and RAW modes
are as shown in Figure 2-1 and Figure 2-2.
Figure 2-1 Parameter Definitions in NORMAL Mode
Figure 2-2 Parameter Definitions in RAW Mode
XORigion
YINCrement=VerticalScale/32
XINCrement=1/SampleRate
XORigion
YORigion
YREFerence
YINCrement=VerticalScale/32
XINCrement=TimeScale/100
XREFerence
XREFerence
YORigion
YREFerence