User Manual

RIGOL 1 Quick Start
DS4000 User’s Guide
1-8
To Connect the Probe
RIGOL provides passive and active probes for the DS4000 series oscilloscopes. For
detailed technical information of the probes, please refer to the corresponding Probe
User’s Guide. The following are the probes recommended for this oscilloscope.
Model
Description
RP3500
500 MHz, passive probe, standard, auto detection
RP7150
1.5 GHz, active probe, optional, auto detection
Connect the Probe:
1. Connect the BNC terminal of the probe to a channel BNC connector of the
oscilloscope at the front panel.
2. Connect the probe tip to the circuit point to be tested and connect the ground
alligator clip of the probe to the circuit ground terminal.
Figure 1-6 To Connect the Probe