User Manual

RIGOL 13 System Function Setting
DS4000 User’s Guide
13-14
Aux Output
Users can set the type of the signal output from the [Trig Out/Calibration]
connector at the rear panel.
Press Utility  AuxOutput to select the desired output type.
1. TrigOut
After this type is selected, the oscilloscope outputs a signal that can reflect the
current capture rate of the oscilloscope at each trigger.
2. Fast
After this type is selected, the oscilloscope can output a fast edge signal which
can be used in the self-calibration of the oscilloscope.
3. GND
After this type is selected, the oscilloscope can output a ground level.
4. PassFail
After this type is selected, the oscilloscope will output a pulse signal when failed
waveforms are detected. This signal can be connected to other control systems
to conveniently view the test results.