User Manual

RIGOL 10 Waveform Record
DS4000 User’s Guide
10-8
Waveform Analysis
This function is used to analyze the recorded waveform. Press Record  Mode and
use to select “Analyze” to open the waveform analysis menu. At this point, the
screen is divided into two display areas as shown in the figure below.
Please refer to the following explanations to set the waveform analysis parameters.
1. Analyze
Press Analyze to select the desired analysis mode.
 Trace: perform analysis on the basis of the templet selected by users. For
detailed information, refer to “Analysis Based on Trace”.
 Pass/Fail: perform analysis on the basis of the Pass/Fail mask created by
users. For detailed information, refer to “Analysis Based on Pass/Fail
Mask”.
2. Source
Press Source to select the channel to be analyzed. Note that only channels
currently enabled can be selected.
Settings and Results Templet Display Current Frame