User Manual

RIGOL 7 Protocol Decoding
DS4000 User’s Guide
7-20
7. Display-related Setting
Press Package to set whether to display the FlexRay in package.
Press Format to set the display format of the bus to Hex, Decimal, Binary or
ASCII.
Press Offset and use to adjust the vertical display position of the bus.
Press BusStatus to enable or disable bus display.
8. Decoding Table
The decoding table lists the decoded data, the corresponding time and error
information in table format. It can be used to observe relatively longer decoded
data to solve the problem that some data could not be seen clearly on the
screen.
Press Event Table  Event Table to select “ON” (note that this operation is
only available when BusStatus is set to “ON”) to enter the decoding table
interface as shown in the figure below. If an USB storage device is currently
connected to the instrument, press Export to export the data table to the
external USB storage device in CSV format.
9. Explanation of the Decoded FlexRay Frame Data
The decoded FlexRay frame data is as shown in the figure below.