User manual

11 Display Control RIGOL
DS2000A User’s Guide
12-13
this operation can align their phase. Acquire the waveforms of the two channels
using the oscilloscope and display the waveforms stably. After switching the
channel status, the phase deviation between the two waveforms is changed. At
this point, press AlignPhase and the phase deviation shown on the oscilloscope
will restore to the current phase deviation between the two waveforms
automatically.
7. Select waveform
Select the arbitrary waveform in the internal or external memory.
8. Create waveform
Users define their own arbitrary waveform.
9. Edit waveform
Edit the arbitrary waveform stored.
10. Modulation
Press Modulation to turn on or off the modulation function. For detailed
introduction of the modulation function, please refer to
Modulation.
11. Set the impedance
Press Impedance to set the output impedance of the signal generator. It can be
set to “HighZ” or “50Ω”.
The following setion introduces how to To Select Waveform, To Create
Waveform and To Edit Waveform.
To Select Waveform
Users can select arbitrary waveforms in the internal memory for output. Press
SelectArb StoredWform, use to select the desired waveform and press
Load. You can also edit the waveform currently selected; for details, refer to the
introduction in
To Edit Waveform.