Datasheet

DC Offset Accuracy ±0.1 div ± 2 mV ± 1% offset value
Channel to Channel Isolation DC to maximum bandwidth: >40 dB
Trigger
Trigger Level Range
Internal ± 5 div from center of the screen
EXT ± 4 V
Trigger Mode Auto, Normal, Single
Holdoff Range 100 ns to 10 s
High Frequency Rejection
1
75 kHz
Low Frequency Rejection
1
75 kHz
Trigger Sensitivity 1 div (below 10 mV or noise rejection is enabled)
0.3 div (above 10 mV and noise rejection is disabled)
Edge Trigger
Edge Type Rising, Falling, Rising&Falling
Pulse Trigger
Pulse Condition Positive Pulse Width (greater than, lower than, within specic interval)
Negative Pulse Width (greater than, lower than, within specic interval)
Pulse Width Range 2 ns to 4 s
Runt Trigger
Pulse Width Condition None, >, <, <>
Pulse Polarity Positive, Negative
Pulse Width Range 2 ns to 4 s
Windows Trigger (Option)
Windows Type Rising, Falling, Rising&Falling
Trigger Position Enter, Exit, Time
Windows Time 16 ns to 4 s
Nth Edge Trigger (Option)
Edge Type Rising, Falling
Idle Time 16 ns to 10 s
Edge Number 1 to 65535
Slope Trigger
Slope Condition Positive Slope (greater than, lower than, within specic interval)
Negative Slope (greater than, lower than, within specic interval)
Time Setting 2 ns to 4 s
Video Trigger (HDTV Option)
Signal Standard Support standard NTSC, PAL and SECAM broadcasting standards; support 480P, 576P, 720P, 1080P and
1080I HDTV standards
Pattern Trigger
Pattern Setting H, L, X, Rising, Falling
Delay Trigger (Option)
Edge Type Rising, Falling
Delay Type >, <, <>, ><
Delay Time 2 ns to 4 s
TimeOut Trigger (Option)
Edge Type Rising, Falling, Rising&Falling
Timeout time 16 ns to 4 s
Duration Trigger (Option)
Pattern H, L, X
Trigger Condition >, <, <>
Duration Time 2 ns to 4 s
Setup/Hold Trigger
Edge Type Rising, Falling
Data Type H, L
Setup Time 2 ns to 1 s
Hold Time 2 ns to 1 s
RS232/UART Trigger
Polarity Normal, Invert
Trigger Condition Start, Error, Check Error, Data
Baud Rate 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps, 57600 bps, 115200 bps, User
Data Bits 5 bit, 6 bit, 7 bit, 8 bit
I2C Trigger
Trigger Condition Start, Restart, Stop, Missing ACK, Address, Data, A&D
Address Bits 7 bit, 8 bit, 10 bit
Address Range 0 to 127, 0 to 255, 0 to 1023
Byte Length 1 to 5
RIGOL
6