User manual

RIGOL 17 Specifications
DS2000A User’s Guide
17-6
Setting
CAN Trigger
Signal Type
Rx, Tx, CAN_H, CAN_L, Differential
Trigger
Condition
SOF, EOF, FrameType, FrameError
Signal Rate 10 kbps, 20 kbps, 33.3 kbps, 50 kbps, 62.5 kbps, 83.3 kbps, 100
kbps, 125 kbps, 250 kbps, 500 kbps, 800 kbps, 1 Mbps, User
Sample Points 5% to 95%
Frame Type Data, Remote, Error, OverLoad
Error Type Bit Fill, AnswerError, CheckError, FormatError, RandomError
USB Trigger (Option)
Signal Speed Low Speed, Full Speed
Trigger
condition
SOP, EOP, RC, Suspend, Exit Suspend
Measure
Cursor
Manual Mode
Voltage Deviation between Cursors (
△
V)
Time Deviation between Cursors (
△
T)
Reciprocal of
△
T (Hz) (1/
△
T)
Track Mode Voltage and Time Values of the Waveform
Point
Auto Mode Allow to display cursors during auto
measurement
Auto
Measurement
Measurements of Maximum, Minimum, Peak-Peak Value, Top
Value, Bottom Value, Amplitude, Average, Mean Square Root,
Overshoot, Pre-shoot, Frequency, Period, Rise Time, Fall Time,
Positive Pulse Width, Negative Pulse Width, Positive Duty Cycle,
Negative Duty Cycle, Delay AB
, Delay AB , Phase AB ,
Phase AB
, Area, Period Area
Number of
Measurements
Display 5 measurements at the same time.
Measurement
Range
Screen or cursor.
Measurement
Statistic
Average, Max, Min, Standard Deviation, Number of Measurements