User`s guide

1 Quick Start RIGOL
DS2000 User’s Guide
1-7
To Connect the Probe
RIGOL provides passive probes for the DS2000 series oscilloscopes. For detailed
technical information of the probes, please refer to the corresponding Probe User’s
Guide. The following are the probes recommended for this oscilloscope.
Model Description
RP3300 350 MHz, passive probe, standard
RP3500A 500 MHz, passive probe, optional
Connect the Probe:
1. Connect the BNC terminal of the probe to a channel BNC connector of the
oscilloscope at the front panel.
2. Connect the probe tip to the circuit point to be tested and connect the ground
alligator clip of the probe to the circuit ground terminal.
Figure 1-5 To Connect the Probe