User`s guide

RIGOL 13 System Function Setting
DS2000 User’s Guide
13-2
Remote Interface Configuration
DS2000 can communicate with PC via LAN, USB and GPIB (with the USB-GPIB
interface converter provided by RIGOL) buses. Please refer to the introduction
below to configure the corresponding interface before using the remote interfaces.
LAN Setting
Press Utility  IO Setting  LAN Set to turn on the LAN setting interface. You
can view the network connection status and configure the network parameters.
Network Status
Connect the oscilloscope to your local area network using the network cable. The
network hole of the oscilloscope is at the rear panel. The oscilloscope will give
different prompts according to the current network connection status.
 Net Config Success!
 Acquire IP…
 IP Conflict!
 Unconnected!
 DHCP Fail!
 Read Status Fail!
Network Status
Current IP
Config Type
MAC Address
VISA Address
IP Config Type
Status