User`s guide

RIGOL 10 Waveform Record
DS2000 User’s Guide
10-8
Waveform Analysis
This function is used to analyze the recorded waveform. Press Utility Record 
Mode and use to select “Analyze” to open the waveform analysis menu. At this
point, the screen is divided into two display areas as shown in the figure below.
Please refer to the following explanations to set the waveform analysis parameters.
1. Analyze
Press Analyze to select the desired analysis mode.
 Trace: perform analysis on the basis of the templet selected by users. For
detailed information, refer to “Analysis Based on Trace”.
 Pass/Fail: perform analysis on the basis of the Pass/Fail mask created by
users. For detailed information, refer to “Analysis Based on Pass/Fail
Mask”.
2. Source
Press Source to select the channel (CH1 or CH2) to be analyzed. Note that only
channels currently enabled can be selected.
3. Start
Press Satrt to enable waveform analysis. Note that during the analysis process,
Settings and Results Templet Display Current Frame