User`s guide

RIGOL 9 Pass/Fail Test
DS2000 User’s Guide
9-4
the screen (if display is turned on) and only one pulse is output from the
[Trigger Out] connector (if enabled) at the rear panel.
 OFF: the oscilloscope will continue with the test even though failed waveforms
are detected. The test results on the screen will update continuously and a pulse
will be output from the [Trigger Out] connector at the rear panel each time a
failed waveform is detected.
Press Output to select “Fail” or “Fail+ ”.
 Fail: when failed waveforms are detected, there are display and output but the
beeper does not sound.
 Fail+
: when failed waveforms are detected, there are display and output and
the beeper sounds (not related to the on/off state of the sound).
Press AuxOutput to quickly turn “ON” or “OFF” the output of test results from the
[Trigger Out] connector at the rear panel. You can also press Utility 
AuxOutput and select “PassFail” to set this output.
To Save the Test Mask
Users can save the current test mask to the internal Flash memory or external USB
storage device. The file format of the test mask file is “*.pf”. The internal memory
can store at most 10 test mask files (LocalPF.pf).
Press Save to enter the file store interface. Please refer to the relative descriptions in
“
Store and Recall” to save the test mask file to the internal or external memory.