User manual

RIGOL Chapter 12 Signal Source
DS1000Z User’s Guide
12-14
10. Modulation
Press Modulation to turn the modulation function on or off. For detailed
information about modulation function, please refer to “
Modulation”.
11. To set impedance
Press Impedance to set the output impedance of the current signal, “HighZ”
and “50Ω” can be selected.
The following will introduce how to “To Select Waveform”, “To Create
Waveform”, and “To Edit Waveforms”.
To Select Waveform
Users can select arbitrary waveforms stored in the interal memory to output. Press
Select  Load and use to select desired waveform. You also can edit the
waveform currently selected and please refer to the instruction of “
To Edit
Waveforms”.
To Create Waveforms
Users can create arbitrary waveforms according to their need. Press Create to enter
the waveform creation interface.
1. To set the number of initial points
When creating a new waveform, the waveform editor will automatically create a
waveform with two points. By default, point 1 is located at 0 s and point 1 is
located at half of the specified period.
Press InitPoint and use to set the initial points of the new waveform and
the arbitrary waveform points can be up to 16384 (16 kpts).
2. Interpolation
Press Interp to turn the interpolation between the defined waveform points on or