Datasheet

RIGOL
6
Trigger
Trigger Level Range ±5 div from the center of the screen
Trigger Mode Auto, Normal, Single
Holdoff Range 16 ns to 10 s
High Frequency Rejection
[1]
75 kHz
Low Frequency Rejection
[1]
75 kHz
Trigger Sensitivity
[1]
1.0div (below 5mV or noise rejection is enabled)
0.3div (above 5mV and noise rejection is disabled)
Edge Trigger
Edge Type Rising, Falling, Rising&Falling
Pulse Trigger
Pulse Condition Positive Pulse Width (greater than, lower than, within specied interval)
Negative Pulse Width (greater than, lower than, within specied interval)
Pulse Width Range 8 ns to 10 s
Runt Trigger
Pulse Condition None, > (greater than), < (lower than), <> (within the specied interval)
Polarity Positive, Negative
Pulse Width Range 8 ns to 4 s
Windows Trigger
Windows Type Rising, Falling, Rising&Falling
Trigger Position Enter, Exit, Time
Windows Time 8 ns to 10 s
Nth Edge Trigger
Edge Type Rising, Falling
Idle Time 16 ns to 10 s
Number of Edges 1 to 65535
Slope Trigger
Slope Condition Positive Slope (greater than, lower than, within specied interval)
Negative Slope (greater than, lower than, within specied interval)
Time Setting 8 ns to 10 s
Video Trigger
Signal Standard Support standard NTSC, PAL and SECAM broadcasting standards
Support 480P, 576P HDTV standards
Pattern Trigger
Pattern Setting H, L, X, Rising Edge, Falling Edge
Delay Trigger
Edge Type Rising, Falling
Delay Type > (greater than), < (lower than), <> (within the specied interval), >< (outside the specied interval)
Delay Time 8 ns to 10 s
TimeOut Trigger
Edge Type Rising, Falling, Rising&Falling
TimeOut Value 16 ns to 10 s
Duration Trigger
Pattern Setting H, L, X
Trigger Condition > (greater than), < (lower than), <> (within the specied interval)
Duration Time 8 ns to 10 s
Setup/Hold Trigger
Edge Type Rising, Falling
Data Pattern H, L,X
Setup Time 8 ns to 1 s
Hold Time 8 ns to 1 s
RS232/UART Trigger
Polarity Normal, Invert
Trigger Condition Start, Error, Check Error, Data
Baud 2400 bps, 4800 bps, 9600 bps, 19200 bps, 38400 bps, 57600 bps, 115200 bps, User
Data Bits 5 bits, 6 bits, 7 bits, 8 bits
I2C Trigger
Trigger Condition Start, Restart, Stop, Missing Ack, Address, Data, A&D
Address Bits 7 bits, 8 bits, 10 bits
Address Range 0x0 to 0x7F, 0x0 to 0xFF, 0x0 to 0x3FF
Byte Length 1 to 5
SPI Trigger
Trigger Condition TimeOut, CS
Timeout Value 16 ns to 10 s
Data Bits 4 bit to 32 bit
Data Line Setting H, L, X