User manual

RIGOL Chapter 18 Specifications
18-6 MSO1000Z/DS1000Z User’s Guide
Measure
Cursor
Manual Mode
Voltage Deviation between Cursors (△V)
Time Deviation between Cursors (
△
T)
Reciprocal of △T (Hz) (1/△T)
Track Mode
Voltage and Time Values of the Waveform
Point
Auto Mode
Allow to display cursors during auto
measurement
Auto
Measurement
Analog channel:
Period, Frequency, Rise Time, Fall Time, Positive Pulse Width,
Negative Pulse Width, Positive Duty Cycle, Negative Duty
Cycle, tVmax, tVmin, Positive Rate, Negative Rate, Delay
12
, Delay 12 , Phase 12 , Phase 12 , Maximum,
Minimum, Peak-Peak Value, Top Value, Bottom Value,
Amplitude, Upper Value, Middle Value, Lower Value, Average,
Vrms, Overshoot, Pre-shoot, Area, Period Area, Period Vrms,
Variance
Digital channel:
Period, Frequency, Positive Pulse Width, Negative Pulse Width,
Positive Duty Cycle, Negative Duty Cycle, Delay 12
, Delay
12 , Phase 12 , Phase 12
Number of
Measurements
Display 5 measurements at the same time
Measurement
Range
Screen or cursor
Measurement
Statistic
Average, Max, Min, Standard Deviation, Number of
Measurements
Frequency
Counter
Hardware 6 bit frequency counter
(channels are selectable)
Math Operation
Waveform
Operation
A+B, A-B, A×B, A/B, FFT, A&&B, A||B, A^B, !A, Intg, Diff, Sqrt,
Lg, Ln, Exp, Abs, Filter
FFT Window
Function
Rectangle, Hanning, Blackman, Hamming, Flat Top, Triangle
FFT Mode
Trace, Memory
FFT Display
Half, Full
FFT Vertical Scale
dB/dBm, Vrms
Filter
Low Pass Filter, High Pass Filter, Band Pass Filter, Band Stop
Filter
Number of Buses
for Decoding
2
Decoding Type
Parallel (standard), RS232/UART (optional), I2C (optional), SPI
(optional)