Data Sheet

6
Delay Time 8 ns to 10 s
TimeOut Trigger
Edge Type Rising, Falling, Rising/Falling
Timeout time 16 ns to 10 s
Duration Trigger
Pattern H, L, X
Trigger Condition >, <, <>
Duration Time 8 ns to 10 s
Setup/Hold Trigger
Edge Type Rising, Falling
Data Pattern H, L
Setup Time 8 ns to 1 s
Hold Time 8 ns to 1 s
RS232/UART Trigger
Polarity Normal, Invert
Trigger Condition Start, Error, Check Error, Data
Baud Rate
2400 bps, 4800 bps, 9600 bps, 19200
bps, 38400 bps, 57600 bps, 115200 bps,
230400 bps, 460800 bps, 921600 bps, 1
Mbps and User
Data Bits 5 bits, 6 bits, 7 bits, 8 bits
I2C Trigger
Trigger Condition
Start, Restart, Stop, MissedAck, Address,
Data, A&D
Address Bits 7 bits, 8 bits, 10 bits
Address Range 0 to 127, 0 to 255, 0 to 1023
Byte Length 1 to 5
SPI Trigger
Trigger Condition Timeout, CS
Timeout Value 100 ns to 1 s
Data Bits 4 bits to 32 bits
Data Line Setting H, L, X
Measure
Cursor
Manual
mode
Voltage deviation between cursors
(△V)
Time deviation between cursors
(△T)
Reciprocal of △T (Hz) (1/△T)
Track
mode
Voltage and time values of the
waveform point
Auto
mode
Allow to display cursors during
auto measurement
Auto
Measurement
Period, Frequency, Rise Time, Fall Time,
Positive Pulse Width, Negative Pulse Width,
Positive Duty Cycle, Negative Duty Cycle,
tVmax, tVmin, Positive Rate, Negative Rate,
Delay 12 , Delay 12 , Phase 12 ,
Phase 12 , Maximum, Minimum, Peak-Peak
Value, Top Value, Bottom Value, Amplitude,
Upper Value, Middle Value, Lower Value,
Average, Vrms, Overshoot, Pre-shoot, Area,
Period Area, Period Vrms, Variance
Number of
Measurements
Display 5 measurements at the same time.
Measurement
Range
Screen or cursor
Measurement
Statistic
Average, Max, Min, Standard Deviation,
Number of Measurements
Counter
Hardware 6-digit counter (channels are
selectable)
Math Operation
Waveform Operation
A+B, A-B, A×B, A/B, FFT, A&&B, A||B,
A^B, !A, Intg, Di󰀨, Sqrt, Lg, Ln, Exp, Abs,
Filter
FFT Window
Rectangle, Hanning, Blackman,
Hamming, Flat Top, Triangle
FFT Mode Trace, Memory
FFT Display Half, Full
FFT Vertical Scale dB/dBm, Vrms
Filter
Low Pass Filter, High Pass Filter, Band
Pass Filter, Band Stop Filter
Number of Buses for
Decoding
2
Decoding Type Parallel, RS232/UART, I2C, SPI
Display
Screen Type 7.0-inch TFT LCD display
Display Resolution 800 horizontal × RGB × 480 vertical pixel
Display Color 16 million color (24-bit true color)
Persistence Time
Min, 100 ms, 200 ms, 500 ms, 1 s, 5 s, 10
s, Innite
Display Type Dots, Vector
I/O
Standard Ports
USB Host, USB Device, LAN, Aux Output
(TrigOut/PassFail)
General Specications
Probe Compensation Output
Output Voltage
[1]
About 3 V, peak-peak
Frequency
[1]
1 kHz
Power
Power Voltage 100 V to 240 V, 45 Hz to 440 Hz
Power Maximum 50 W
Fuse 2 A, T degree, 250 V
Environment
Temperature Range
Operating: 0℃ to +50℃
Non-operating: -40℃ to +60℃
Cooling Method Fan cooling
Humidity Range
0℃ to +30℃: ≤95% relative humidity
+30℃ to +40℃: ≤75% relative humidity
+40℃ to +50℃: ≤45% relative humidity
Altitude
Operating: under 3,000 meters
Non-operating: under 15,000 meters
Mechanical
Dimensions
[3]
Width × Height × Depth = 313.1 mm ×
160.8 mm × 122.4 mm
Weight
[4]
Without Package 2.9 kg ± 0.2 kg
With Package 3.5 kg ± 0.5 kg
Calibration Interval
The recommended calibration interval is 18 months.