User`s guide

Chapter 2 To Set the Vertical System RIGOL
DS1000Z User’s Guide
2-7
Channel Label
To identify different analog channels, you can set another label for each channel
(such as ). Press CH1 Label to enter the label setting menu, you can use
the built-in label or input the label manually and the length of the label inputted
manually cannot exceed 4 characters. Note: Only English lowercase input method
can be used for this operation.
Press Display to turn on or off the display of channel label and the default is CH1.
Press Label Edit to enable the label editing interface as shown in the figure below.
Figure 2-1 Label Editing Interface
For example, set the label to “
”.
Press Keyboard to select the “Keyboard” area. Select “Aa” using and press
down
to switch it to “
a
A”. Select “C” using and press down to input the
character. Use the same method to input “hn1”.
To modify or delete the input character, press Name to select the “Name Input Area”
and use
to select the character to be modified or deleted. Enter the desired
character or press Delete to delete the character selected.
After finishing the input, press OK to finish the modification. If Display is set to
“ON”, the label
will be displayed at the left of the CH1 waveform.
Name Input Area Keyboard Upper/Lower Case Switch