User`s guide

Chapter 1 Quick Start RIGOL
DS1000Z User’s Guide
1-17
optimum waveform display. Note that auto setting requires that the
frequency of the signal under test should be no lower than 41Hz,
the duty cycle be greater than 1% and the amplitude be at least
20mVpp. Otherwise, “Auto detected none!” would be displayed
after pressing this key and the quick parameter measurement
menu might not be displayed.
RUN/STOP
Press this key to set the state of the oscilloscope to “RUN” or
“STOP”. In “RUN” state, the key is illuminated in yellow. In “STOP”
state, the key is illuminated in red.
SINGLE
Press this key to set the trigger mode to “Single”. In single trigger
mode, press FORCE to generate a trigger signal immediately.
Knob
Adjust waveform brightness:
In non-menu-operation mode, turn this knob to adjust
the brightness of waveform display. The adjustable range
is from 0% to 100%. Turn clockwise to increase the
brightness and counterclockwise to reduce. Press down
this knob to reset the brightness to 50%.
You can also press Display  Intensity and use the
knob to adjust the waveform brightness.
Multifunction Knob (the backlight goes on during operation):
In menu operation, press any menu softkey and turn the knob to switch the desired
submenu under this menu and then press down the knob to select the current
submenu. It can also be used to modify parameters and input filename. In addition,