User`s guide

RIGOL Chapter 1 Quick Start
DS1000Z User’s Guide
1-16
compressed mode and the time base message (e.g. ) at the upper side of
the screen would change accordingly. Press down this knob to quickly switch to
delayed sweep state.
TRIGGER
MODE: press this key to switch the trigger mode to Auto, Normal
or Single and the corresponding state backlight of the current
trigger mode would be illuminated.
TRIGGER
LEVEL: modify the trigger level. Turn clockwise to
increase the level and turn counterclockwise to reduce the level.
During the modification, the trigger level line would move up and
down and the value in the trigger level message box (e.g.
) at the lower-left corner of the screen would
change accordingly. Press down the knob to quickly reset the
trigger level to zero point.
MENU: press this key to open the trigger operation menu. This oscilloscope
provides various trigger types (for details, refer to the introductions in “To Trigger
the Oscilloscope
”).
FORCE: press this key to generate a trigger signal forcefully.
CLEAR
Press this key to clear all the waveforms on the screen. If the
oscilloscope is in “RUN” state, new waveforms will still be displayed.
AUTO
Press this key to enable the waveform auto setting function. The
oscilloscope will automatically adjust the vertical scale, horizontal
time base and trigger mode according to the input signal to realize