User`s guide

Chapter 1 Quick Start RIGOL
DS1000Z User’s Guide
1-15
Tip
How to set the vertical scale and vertical position of each channel?
The four channels of the DS1000Z series digital oscilloscope use the same set of
VERTICAL
POSITION and VERTICAL SCALE knobs. To set the vertical
scale and vertical position of a channel, press CH1, CH2, CH3 or CH4 to select
the desired channel and then rotate the VERTICAL POSITION and
VERTICAL
SCALE knobs.
Source
Press this key to enter the source setting interface. You can set
the waveform of the output signal of the source and the
waveform parameters, turn on or off the outputs of the
[Source1] and [Source2] connectors at the rear panel, view
the signal states (such as the frequency, amplitude, offset and
phase).
HORIZONTAL
HORIZONTAL POSITION: modify the horizontal position.
The trigger point would move left or right relative to the center of
the screen when you turn the knob. During the modification,
waveforms of all the channels would move left or right and the
horizontal position message (e.g.
) at the
upper-right corner of the screen would change accordingly. Press
down this knob to quickly reset the horizontal position (or the
delayed sweep position).
MENU: press this key to open
the horizontal control menu under which to turn on
or off the delayed sweep function, switch between different time base modes.
HORIZONTAL SCALE: modify the horizontal time base. Turn clockwise to
reduce the time base and turn counterclockwise to increase the time base. During
the modification, waveforms of all the channels will be displayed in expanded or