User`s guide

RIGOL Chapter 14 System Function Setting
DS1000Z User’s Guide
14-2
Remote Interface Configuration
DS1000Z can communicate with the PC via LAN, USB or GPIB (option) interface. The
instrument detects the interface connection states automatically and displays the
current interface connection states in Utility  IO Setting  RemoteIO. Please
refer to the introduction below to configure the corresponding interface before using
the remote interfaces.
LAN Setting
Press Utility  IO Setting  LAN Conf. to turn on the LAN setting interface. You
can view the network connection status and configure the network parameters.
Network Status
Connect the oscilloscope to your local area network using a network cable. The
network hole of the oscilloscope is at the rear panel. The oscilloscope will give
different prompts according to the current network connection status.
 Net Config Success!
 Acquire IP…
 IP Conflict!
 Unconnected!
 DHCP Fail!
 Read Status Fail!
Network Status
Current IP
Config Type
MAC Address
VISA Address
IP Config Type
Status