User`s guide

Chapter 12 Signal Source RIGOL
DS1000Z User’s Guide
12-17
4. Voltage
Press Voltage to set the voltage value of the current point and the range
available is from -2.5 V to +2.5 V.
5. Time
Press Time to set the duration time of the current point and this setting is
limited by the duration times of the previous point and the next point. Point 1 is
fixed at 0 s.
6. Insert point
Press Insert to insert a new point at the middle position of the current edited
point and the next edited point.
7. Delete point
Press Delete to delete the current point from the waveform and connect the
remaining points using the current interpolation method. Note that point 1
cannot be deleted.
8. Apply
Press Apply to apply the waveform currently edited.
9. Save
Press Save to enter the files store interface. Please refer to the instruction of
“
Store and Recall” to save the waveform files currently created in the internal
or external memory in “.arb” format (if the current position exist a file, you can
overwrite the original file or save the waveform currently edited again). You can
output the arbitrary waveforms saved in the internal or external memory and for
the specified operation, please refer to the instruction of “To Select
Waveform”.