User`s guide

RIGOL Chapter 12 Signal Source
DS1000Z User’s Guide
12-1
6
9. Apply
Press Apply to apply the waveform currently edited.
10. Save
Press Save to enter the files store interface. Please refer to the instruction of
“
Store and Recall” to save the waveform files currently created in the internal
or external memory in “.arb” format (if the current position exist a file, you can
overwrite the original file or save the waveform currently edited again). You can
output the arbitrary waveforms saved in the internal or external memory and for
the specified operation, please refer to the instruction of “To Select
Waveform”.
To Edit Waveform
Users can edit the waveforms which have been already saved. Press Edit to enter
the waveform editing interface.
1. Interpolation
Press Interp to turn the interpolation method between the defined waveform
points on or off.
 ON: the waveform editor will connect two defined points with a straight
line.
 OFF: the waveform editor will hold a constant voltage level between two
defined points and create a step waveform.
2. Zoom
Press Zoom to turn the zoom function on or off.
 ON: only display the current point in the middle of the waveform editor
window.
 OFF: display all the initial points in the waveform editor window.
3. Current point
Press CurPoint and use to set the desired points currently edited and the
range available is from 1 to the number of initial points.