User`s guide

Chapter 12 Signal Source RIGOL
DS1000Z User’s Guide
12-15
3. Zoom
Press Zoom to turn the zoom function on or off.
 ON: only display the current point in the middle of the waveform editor
window.
 OFF: display all the initial points in the waveform editor window.
4. Current point
Press CurPoint and use to set the desired point currently edited and the
range available is from 1 to the number of initial points.
5. Voltage
Press Voltage to set the voltage value of the current point and the range
available is from -2.5 V to +2.5 V.
6. Time
Press Time to set the duration time of the current point and this setting is
limited by the duration times of the previous point and the next point. Point 1 is
fixed at 0 s.
7. Insert
Press Insert to insert a new point at the middle position of the current edited
point and the next edited point.
8. Delete
Press Delete to delete the current point from the waveform and connect the
remaining points using the current interpolation method. Note that point 1
cannot be deleted.