User`s guide

RIGOL Chapter 12 Signal Source
DS1000Z User’s Guide
12-1
4
To Select Waveform
Users can select arbitrary waveforms stored in the interal memory to output. Press
Select  Load and use to select the desired waveform. You also can edit the
waveform currently selected and please refer to the instruction of “To Edit
Waveform”.
To Create Waveform
Users can create arbitrary waveforms according to their needs. Press Create to
enter the waveform creation interface.
1. To set the number of initial points
When creating a new waveform, the waveform editor will automatically create a
waveform with two points. By default, point 1 is located at 0 s and point 1 is
located at half of the specified period.
Press InitPoint and use to set the number of initial points of the new
waveform and the number of arbitrary waveform points can be up to 16384 (16
kpts).
2. Interpolation
Press Interp to turn the interpolation between the defined waveform points on
or off.
 ON: the waveform editor will connect two defined points with a straight line.
 OFF: the waveform editor will hold a constant voltage level between two
defined points and create a step waveform.