User`s guide

Chapter 12 Signal Source RIGOL
DS1000Z User’s Guide
12-13
6. Align phase
Press AlignPhase to re-configre the two channels and enable the signal source
to output with specified frequency and phase. For two signals whose frequencies
are the same or in multiple, this operation will align their phases. Use the
oscilloscope to sample and display the waveforms of the two channels and you
will see that the phases of the two waveforms shown on the oscilloscope
changed. At this point, press AlignPhase and the waveforms on the oscilloscope
will restore the current phase deviation of the two channels.
7. Select waveform
Select the arbitrary waveform stored in the internal or external memories.
8. Create waveforms
Users can define their own arbitrary waveforms. For detailed information please
refer to “To Create Waveform”.
9. Edit waveform
Edit the arbitrary waveforms already stored. For detailed information please refer
to “To Edit Waveform”.
10. Modulation
Press Modulation to turn the modulation function on or off. For detailed
information about the modulation function, please refer to “
Modulation”.
11. To set impedance
Press Impedance to set the output impedance of the signal source to “HighZ”
or “50Ω”.
The following parts introduce how “To Select Waveform”, “To Create
Waveform”, and “To Edit Waveform”.