User`s guide

Chapter 12 Signal Source RIGOL
DS1000Z User’s Guide
12-7
To Output Built-In Waveform
The built-in siganle source of DS1000Z provides 7 kinds of built-in waveforms
including Sinc, Exp.Rise, Exp.Fall, ECG, Guass, Lorentz, Haversine. Press Src1Conf
to enter the waveform setting interface. Press Wave to select “Built-In”, at this point,
you can set the relative parameters of the output signal according to the built-in
waveform type selected.
1. Output
Press Output to turn the signal output on or off.
2. To select the built-in waveform
Press Built-In to select any one of the 7 kinds of built-in waveforms. The 7 kinds
of built-in waveforms are as shown in the figures below.
Figure 12-1 Built-in Waveform-Sinc