User`s guide

RIGOL Chapter 12 Signal Source
DS1000Z User’s Guide
12-4
To Output Square Waveform
Press Src1Conf to enter the waveform setting interface. Press Wave to select
“Square”, at this point, you can set the square waveform parameters. For the
specified setting method, please refer to the instruction of “
To Output Sine
Waveform”.
To Output Ramp Waveform
Press Src1Conf to enter the waveform setting interface. Press Wave to select
“Ramp”, at this point, you can set the ramp waveform parameters. For the specified
setting method, please refer to the instruction of “
To Output Sine Waveform”.
Only “symmetry” is introduced in this chapter.
Symmetry
Symmetry is difined as the percentage that the rising period of ramp waveform takes
up in the whole period, as shown in the figure below.
T
t
Symmetry=t/T*100%
Press Symmetry and use to set the symmetry of the current ramp. For the
setting methods, refer to “Parameter Setting Methods”. The range available is
from 0% to 100%.