User`s guide

Chapter 12 Signal Source RIGOL
DS1000Z User’s Guide
12-1
Chapter 12 Signal Source
DS1000Z which combines the signal generator and oscilloscope in one by providing a
dual-channel, 25 MHz signal source, is very convenient for the engineers who need
to use both signal source and oscilloscope at the same time. This chapter introduces
how to use the built-in signal source of the oscilloscope. As the function and the
setting method of the two channels of the signal source are the same, this chanpter
only takes Source1 as an example for illustration.
Press Source to enter the signal source setting interface. Press Output to turn the
signal output on or off. When “ON” is selected, the instrument outputs the signal
currently set from the [Source1] connector at the rear panel. Press Src1Conf to
select the type of the signal currently output and set the relative parameters of the
signal. You can press StatusDisp to view the current signal states of SOURCE1 and
SOURCE2 (such as the frequency, amplitude, offset, phase, modulation type and
modulation frequency).
Note: The function of Source  Output is the same with that of Source 
Src1Conf  Output mentioned below.
The contents of this chapter:
 To Output Basic Waveform
 To Output Built-In Waveform
 To Output Arbitrary Waveform