User`s guide

RIGOL Chapter 10 Waveform Record
DS1000Z User’s Guide
10-2
Playback Setting
The waveform playback function can play back the waveforms currently recorded. At
this point, the information as shown in the figure below is displayed at the upper
right corner of the screen. The data on the left indicates the specific frame currently
displayed on the screen and during the playback and this value would change
continuously. The data on the right indicates the maximum number of frames
recorded.
Before playing back the waveform, you can press Play Opt to set the playback
parameters.
1. Play Mode
Press Mode to set the playback mode to cycle or single.
 : cycle. Play from the start frame to the end frame and then repeat
until you stop it manually.

: single. Play from the start frame to the end frame and then stop.
2. Play Direction
Press Dir to set the playback direction to forward direction or inverse direction.
 : forward direction, Play from the start frame to the end frame.

: inverse direction, play from end frame to start frame.
3. Interval
Press Interval and use to set the time interval of playback. The range
availbale is from 100 ns to 10 s and the default is 100 ns.
4. Start Frame
Press Start and use to set the start frame of playbak. The default is 1 and
the maximum is the maximum number of frames recorded.
5. End Frame
Press End and use to set the end frame of the playback. The default is the
total number of frames of the waveform recorded.