User`s guide

RIGOL Chapter 8 Reference Waveform
DS1000Z User’s Guide
8-2
To Enable REF Function
Press REF in the vertical control area (VERTICAL) at the front panel to enable the
REF function.
Note: When the time base is in XY mode, REF function can not be enabled.
DS1000Z provides 10 reference waveform channels. Press Channel and use to
set the desired reference channel to on or off and a channel icon (for example,
)
of the channel enabled will be display at the left side of the screen grid.
When the REF function is enabled, you can select different color for each reference
waveform, set the source of each reference channel, adjust the vertical scale and
position of the reference waveform and save the reference waveform to internal or
external memory as well as recall it when needed. For details, please refer to the
introductions below.
To Select REF Source
Press Current and use to select any of the reference channels (Ref1 to Ref10)
enabled and then press Source to specify a reference source (CH1-CH4 or MATH)
for this channel.
To Adjust REF Waveform Display
To adjust the reference waveform specified in Current:
Press REF to enable the REF function. Then, press Offset and use to adjust the
vertical position of the reference waveform and press Scale and use to adjust
the vertical scale of the reference waveform.