User`s guide

Chapter 7 Protocol Decoding RIGOL
DS1000Z User’s Guide
7-15
Press Evt.Table  EventTable and select “ON” (note: this operation is only
available when Decode is set to “ON”) to enter the event table interface as
shown in
Figure 7-2.
Format: set the display format of the “Data” in the event table to HEX, DEC or
ASC.
Focus: rotate
to select the desired data.
View: set the display format of the vent table to packets, details or payload.
Data: select the data column to be viwed in the “Details” or “Payload” views.
Order: set the display type of the decoding results in the event table to ascend
or descend.
Export: if an USB storage device is currently connected to the instrument, you
can press Export to export the data table to the external USB storage device in
CSV format.
7. Decoding Configuration
Press Decoding1 Configure to turn the decoding configuration submenu on.
 Press Label to turn the label display function on or off. When it is turned on,
the bus label will be displayed at the upper left of the bus (when the bus
display is turned on).
 Press Line to turn the bus display function on or off. When it is turned on,
the bus display will be displayed on the screen, and you can use Pos to
adjust the vertical display position of the bus.
 Press Format to turn the format display function on or off. When it is turned
on, the current format display of the bus will be displayed on the right of the
label display (when the bus display is turned on), and you can use Format
to set the display format of the bus.
 Press Endian to turn the endian display function on or off. When it is turned
on, the current endian display will be displayed on the right of the format
display (when the bus display is turned on), and the default is MSB.
 Press Width to turn the width display function on or off. When it s turned on,
the data width of each frame will be displayed on the right of the endian
display (when the bus display is turned on), and the default is 8.
 Press DataSrc to select “Trace” or “Memory” as the data source.
 Dig. Sa displays the current digital sample rate. The digital sample rate is
related to the data source currently selected. When the data source is set to
“Trace”, the digital sample rate is related to the horizontal time base; when