User`s guide

RIGOL Chapter 7 Protocol Decoding
DS1000Z User’s Guide
7-10
8. Display-related Setting
 Press Format to set the display format of the bus to Hex, Decimal, Binary,
ASCII or LINE. Note that LINE format is displayed the acyual value of the
bus in a binary number form, and the order is consistent with the bus
transmission sequence. This format is only valid for the serial bus, because
the serial bus has the difference of bit sequence of LSB and MSB; if bit
sequence of the bus is selected MSB, the LINE format is the same to the
binary format.
 Press Pos and use to adjust the vertical display position of the bus.
9. Event Table
The event table displays the decoded data and the corresponding line number
and time in table form. It can be used to observe relatively longer decoded data
to solve the problem that some data cannot be viewed cleared on the screen.
Press Evt.Table  EventTable and select “ON” (note: this operation is only
available when Decode is set to “ON”) to enter the event table interface as
shown in
Figure 7-2.
Format: set the display format of the “Data” in the event table to HEX, DEC or
ASC.
Focus: rotate
to select the desired data.
View: set the display format of the vent table to packets, details or payload.
Data: select the data column to be viwed in the “Details” or “Payload” views.
Order: set the display type of the decoding results in the event table to ascend
or descend.
Export: if an USB storage device is currently connected to the instrument, you
can press Export to export the data table to the external USB storage device in
CSV format.
10. Decoding Configuration
Press Decoding1 Configure to turn the decoding configuration submenu on.
 Press Label to turn the label display function on or off. When it is turned on,
the bus label will be displayed at the upper left of the bus (when the bus
display is turned on).
 Press Line to turn the bus display function on or off. When it is turned on,
the bus display will be displayed on the screen, and you can use Pos to
adjust the vertical display position of the bus.