Manualshelf

User`s guide

ManualsBrandsRIGOL ManualsLaboratory Test EquipmentDigital 70 MHz 4-channel 1 null 8 null 8 Bit Digital storage (DSO)
141142143144145146147148149150
RIGOL Chapter 6 To Make Measurements
DS1000Z User’s Guide
6-72
Cursor Measurement
Cursors can be used to measure the X axis values (usually Time) and Y axis values
(usually Voltage) on a selected waveform. Please connect the signal to the
oscilloscope and obtain stable display before using cursor measurement. All the “Auto
Measurement” parameters can be measured through cursor measurement.
Press Cursor Mode at the front panel and use to select the desired cursor
mode (the default is “OFF”) and then press down the knob. The modes available are
“Manual”, “Track” and “Auto”. You can also select the “XY” cursor measurement mode
when the “Time Base Mode” is set to “XY”.