Manualshelf

User`s guide

ManualsBrandsRIGOL ManualsLaboratory Test EquipmentDigital 70 MHz 4-channel 1 null 8 null 8 Bit Digital storage (DSO)
111112113114115116117118119120
RIGOL Chapter 6 To Make Measurements
DS1000Z User’s Guide
5-42
Trigger Output Connector
The trigger output connector ([Trigger Out]) at the rear panel can output trigger
signals determined by the current setting.
When the oscilloscope is triggered, a signal that can reflect the current capture rate
of the oscilloscope will be outputted via [Trigger Out] connector. Connect the signal
to a waveform display instrument to measure the frequency of the signal and the
result is equal to the current capture rate.
Note: When Utility AuxOutput is set to “PassFail” to set or Utility
Pass/Fail AuxOutput selects “ON”, during the pass/fail test, the [Trigger Out]
connector outputs high level when failed waveforms are detected by the oscilloscope
and outputs low level when no failed waveform is detected by the oscilloscope.
Trigger Output Connector