User manual

RIGOL
© 2008 RIGOL Technologies, Inc.
User‟s Guide for DS1000B series
2-4
To set up channel coupling
To use Channel 1 as an example, input a square wave signal with DC shift.
Press CH1→Coupling→DC to set “DC” coupling. Both the AC component and the
DC component of the input signal will pass.
The waveform is displayed as Figure 2-3:
Figure 2-3
Waveform display
Press CH1→Coupling→AC, to set “AC” coupling. It will pass AC component of the
input signal with frequency higher than 5 Hz and restraint DC component of the input
signal.
The waveform is displayed as Figure 2-4:
DC coupling
Setup
DC coupling
Status symbol