User manual

RIGOL

User‟s Guide for DS1000B Series

1-7

Figure 1-5

Attach the probe

② Set the probe attenuation of the oscilloscope to 10X. To do this, push

CH1→Probe→10X.

Figure 1-6 Figure 1-7

Set the probe The CH1 menu

③ Push the AUTO button. Within a few seconds, a square wave will be displayed on

the screen.

④ Push the OFF button or push the CH1 button again to turn off Channel 1.

Push the CH2, CH3, CH4 buttons to turn on channel 2, channel3, channel4, repeat

steps 2 and 3.

NOTE: The signal output from Probe compensator should only be used for probe

compensation, not for calibration.

Probe scale

Probe compensator