User`s guide

RIGOL

User’s Guide for DS1000E, DS1000D Series

1-8

 Align the slot in the probe connector with the button on the CH 1 BNC.

 Push to connect, and twist to the right to lock the probe in place.

 Attach the probe tip and ground lead to the PROBE COMP connector.

Figure 1- 8

Attach the probe

② Set the probe attenuation to 10X. To do this, push CH1→Probe→10X.

Figure 1- 9 Figure 1- 10

Set attenuation on the probe Set attenuation in the menu

③ Push the AUTO button. Within a few seconds, a square wave will display.

④ Push the CH1 button again to turn off Channel 1.

Push the CH2 button to turn on channel 2, repeat steps 2 and 3.

NOTE: The signal output from Probe compensator should only be used for probe

compensation, not for calibration.

Probe compensator

Probe scale