User`s guide

RIGOL
© 2008 RIGOL Technologies, Inc.
User’s Guide for DS1000E, DS1000D Series
2-90
10 Time Measurement Parameters
Figure 2- 126 Table 2- 81 The Time Measurements menu (Page 1/3)
Menu
Settings
Comments
Period
Measure Period of a waveform
Freq
Measure Frequency of a waveform
Rise time
Measure Rise Time of a rising edge
Fall time
Measure Fall Time of a falling edge
Figure 2- 127 Table 2- 82 The Time Measurements menu (Page 2/3)
Menu
Settings
Comments
+Width
Measure +Pulse Width of a pulse wave
-Width
Measure –Pulse Width of a pulse wave
+Duty
Measure +Duty Cycle of a pulse wave
-Duty
Measure –Duty Cycle of a pulse wave
Figure 2- 128 Table 2- 83 The Time Measurements menu (Page 3/3)
Menu
Settings
Comments
Delay1→2
Measure the signals delay between
two channels at the rising edge
Delay1→2
Measure the signals delay between
two channels at the falling edge
NOTE: The results of the automatic measurements will be displayed on the bottom
of the screen. Maximum 3 results could be displayed at the same time. When there
is no room, the next new measurement result will make the previous results moving
left out of screen.