User Manual

Chapter 2 Front Panel Operations RIGOL
DP800 User’s Guide 2-55
Recall the user-defined setting
In the interface as shown in Figure 2-14, press Preset Key to select and set the 4
groups of user-defined settings. At this point, pressing Preset at the front panel will
recall the specified setting.
Press Preset Key to enter the interface as shown in Figure 2-15 (user-defined
setting 1 is selected in the interface). The instrument setting is displayed in the
interface. At this point, pressing Preset at the front panel will recall the
corresponding setting.
Figure 2-15 User-defined Setting Interface
You can modify the parameters of the user-defined setting currently selected.
 Press the channel selection key at the front panel to select the desired channel.
 Press the menu key to modify the voltage, current, OVP, OCP, track and OTP
parameters.
 You can restore the user-defined parameters modified to default values by
pressing Default in the last menu page in the interface as shown in Figure 2-15.
You can also rename the 4 groups of user-defined settings (the default names are
user1 to user4) and the name is displayed at the upper-right corner of the interface
as shown in Figure 2-15. Press Preset Key and use the direction keys and knob to
edit the name.
Options
Press Utility  Option to enter the option interface and you can view the option
installation information. Press Install to enter the filename input interface, the input
method is fixed at “EN”, input the correct serial number and press OK.