User manual
Table Of Contents
- Guaranty and Declaration
- Safety Requirement
- DP800 Series Overview
- Document Overview
- Quick Start
- Front Panel Operations
- Constant Voltage Output
- Constant Current Output
- Power Supply Series and Parallel Connections
- Track Function
- Sense Working Mode
- Timer and Delayer
- Advanced Functions
- Display Setting
- Store and Recall
- Utility
- Key Locking
- Remote Control
- Troubleshooting
- Specifications
- Appendix
- Index
Chapter 2 Front Panel Operations RIGOL
DP800 User’s Guide 2-57
To Set the GPIB Address
Before using the GPIB interface, use the USB to GPIB interface converter (option) to
extend a GPIB interface and then use a GPIB cable to connect the instrument and
PC.
Press Utility I/O Config GPIB and use the numeric keyboard or the left/right
direction key and knob to set the desired GPIB address. It can be any integer from 0
to 30. The default is 2. This setting is stored in the non-volatile memory and will not
be affected by factory reset.