User manual

Chapter 5 Appendix RIGOL
DP700 Programming Guide 5-1
Chapter 5 Appendix
Appendix A: Default Settings
Sending the
*RST command can restore the instrument to default settings, as shown in the table below.
Model DP711 DP712
Channel Parameter
Voltage/Current Setting Value 0 V/5 A 0 V/3 A
OVP/OCP Value 32 V/5.3 A 53 V/3.2 A
OVP/OCP On/Off Off/Off Off/Off
Output On/Off Off Off
System Setting
Beeper On
Screen Saver Off
Trigger Input Off
Trigger Output Off
RS232 Interface Setting
Baud Rate 9600
Stop Bit 1
Data Bit 8
Parity None
Timer
Number of Output Groups 1
Number of Cycles 1
Trigger Mode Auto
End State Output Off
Timing Parameter
Group ID: 1
Output Voltage: 1 V
Output Current: 1 A
Duration Time: 1 s
Tip
When the power-on setting is set to "DEFault" (:SYSTem:POWEron DEFault), it indicates that the
instrument will be restored to defaults once the instrument is powered on again.