User manual

Chapter 2 Command System RIGOL
DP700 Programming Guide 2-1
Chapter 2 Command System
This chapter introduces the syntax, functions, parameters, and usage of each command.
Contents in this chapter:
 :APPLy Command
 :DISPlay Command
 IEEE488.2 Common Commands
 :INSTrument Commands
 :LIC Command
 :MEASure Commands
 :MEMory Commands
 :OUTPut Commands
 :SOURce Commands
 :SYSTem Commands
 :TIMEr Commands
Note: In the command system, the commands with the time, voltage, current, or power parameter are
allowed to be sent with the corresponding unit. Unless otherwise specified, the unit and the default unit for
the parameters are listed in the following table.
Parameter Type Unit Supported Default Unit
Time second (s) second (s)
Voltage volt (V), millivolt (mV) volt (V)
Current ampere (A), milliampere (mA) ampere (A)
Power watt (W), milliwatt (mW) watt (W)