User manual

RIGOL Chapter 3 Remote Control
3-2 DP700 User’s Guide
Figure (a).
(a)
As shown in Figure (a), in the "RS232 Setting" tab, set Baud Rate, Parity, Data
Bits, and Stop Bit that match the current parameters of the RS232 interface of
the instrument (Note: You must select "None" under the "Flow Control" option,
and select "\n" under the "End Mark" option). After completing the settings, click
"Test". If the test succeeds, a dialog box, as shown in Figure (b), is displayed.
(b)
Note: If the test fails, check whether the instrument can communicate with the
PC via the RS232 cable normally, and whether the current RS232 settings in
Ultra Sigma match those of the instrument.
In the dialog box shown in Figure (b), click "OK". Then the "Add" button in the
"RS232 Setting" tab in Figure (a) will be enabled. Click "Add", and then the
currently selected instrument resource will be displayed on the right section of
the window, as shown in Figure (c). Then, click "OK" to add the instrument
resource.
(c)