User manual

RIGOL Chapter 2 Front Panel Operations
2-36 DP700 User’s Guide
2. Install the option
Method 1: Front Panel Operations
(1) In the system option tab, press the Up/Down arrow key to switch the
parameter focus to the desired option.
(2) Press OK to enter the License Input interface.
Figure 2-11 License Input Interface
(3) In the License Input interface, press the Up/Down/Left/Right arrow key or
use the knob to select the desired character (the English letter is not
case-sensitive) on the virtual keypad, and then press OK to enter the
character. The entered characters will be displayed in the "License Input
Area". While entering the characters, press
to delete the unwanted
character if necessary.
Note: The hyphens in the option license should be omitted.
(4) After inputting a license, select "Save" on the virtual keypad and press OK.
If the option has been successfully installed, a prompt message will be
displayed; otherwise, a message indicating a failed installation will be
displayed.
Tip
If you want to quit the installation operation, select "Exit" on the virtual
keypad to give up installing the option, and then press OK.
Method 2: Send SCPI Commands
To set up remote control via the RS232 interface and send the option installation
command :LIC:SET <license>, refer to "Remote Control".
Wherein, <license> is the option license, and the hyphens in the code should be
omitted.
For example, :LIC:SET UVF2L3N3XXKYTB73PPRSA4XDMSRT
License Input Area Virtual Keypad