User manual

RIGOL Chapter 2 Front Panel Operations
2-28 DP700 User’s Guide
Set the Screen Brightness
The settable screen brightness ranges from 1% to 100%.
In the system setting tab, press the Up/Down arrow key to switch the parameter
focus to "Brightness", and then use the num key or knob to select the desired
brightness. For setting method, refer to the descriptions of the help information
displayed at the bottom of the interface or refer to the descriptions in "Parameter
Setting Method".
Turn On/Off the Beeper
When the beeper is turned on, the
icon is displayed in the status bar. In this case,
the beeper sounds when you perform the following operations.
 When you press the keys on the front panel;
 When you rotate the knob;
 When an error occurs in remote operation
.
In the system setting tab, press the Up/Down arrow key to switch the parameter
focus to "Beeper", and then press the Left/Right arrow key or use the knob to turn on
or off the beeper.
Turn On/Off the Screen Saver
When the screen saver function is enabled, if no operation is performed on the front
panel for more than 25 minutes, the instrument automatically enters the screen
saver mode; if it persists for another 12.5 minutes, the screen of the instrument
stays black.
In the system setting tab, press the Up/Down arrow key to switch the parameter
focus to "Screen Saver", and then press the Left/Right arrow key or use the knob to
enable or disable the screen saver function.
Enable the Trigger Function
DP700 series power supply provides the trigger function (optional), including trigger
input and trigger output. For details of the function, refer to the descriptions in
"Trigger". If you want to use the trigger function, order the option based on the
Order No. available in "Appendix A: Order Information", and then install the
option by referring to "Option Configuration".