User manual

RIGOL Chapter 2 Front Panel Operations
2-22 DP700 User’s Guide
in the "File Name Input Area". While entering a name, press to delete
the unwanted character if necessary.
3. Save a file
After inputting a file name, select "Save" on the virtual keypad and press OK to
save the file. After the file is saved, a message will be displayed, prompting you
that you have saved the file.
If there is an existing file in the currently selected location, you can determine
whether to overwrite the existing file. Press the Left/Right arrow key to select
"YES" and press OK to overwrite the existing saved file; select "NO" and press
OK to give up saving the file.
Tip
If you want to quit the saving operation, select "Exit" on the virtual keypad to give
up saving the file, and then press OK.
Recall Files
You are allowed to recall all saved state files and timer files. After the files have been
read, the status information of the instrument or the timer parameters will make
changes accordingly.
Operation Procedures:
1. Press Memory to enter the store and recall interface, and then press the
Up/Down/Left/Right arrow key or use the knob to switch the parameter focus to
the storage location where the file to be recalled can be found.
2. Press OK and then press the Left/Right arrow key or use the knob to select
"Read" to read the saved file in the selected storage location. After the file
reading is complete, a message will be displayed, prompting you that the
reading process is complete.
If no saved file is found in the selected storage location, the "Read" key is
grayed out and disabled.
Delete Files
You are allowed to delete the saved state files and timer files.
Operation Procedures:
1. Press Memory to enter the store and recall interface, and then press the
Up/Down/Left/Right arrow key or use the knob to switch the parameter focus to
the storage location where files to be recalled can be found.