User manual

Chapter 2 Front Panel Operations RIGOL
DP700 User’s Guide 2-21
Manage Files
The internal NVM of the DP700 series power supply provides ten storage locations for
state files and two for timer files. Therefore, you are allowed to save the current
status information of the instrument or its timer parameters to the specified location,
and recall the saved files if necessary.
Store Files
The file name can contain lowercase letters (a-z) and numbers (0-9). The maximum
length of the file name is 11 characters.
Operation Procedures:
1. Specify a storage location
Press Memory to enter the store and recall interface, and then press the
Up/Down/Left/Right arrow key or use the knob to switch the parameter focus to
a desired storage location for state file (State1 to State10) or a desired storage
location for timer file (Timer1 or Timer2).
2. Enter a file name
(1) Press OK and then the file management options are displayed at the
bottom of the interface. By default, "Save" is selected. (You can also press
the Left/Right arrow key or use the knob to select "Save".) Then press OK
to enter the file name input interface.
Figure 2-3 File Name Input Interface
(2) In the file name input interface, press the Up/Down/Left/Right arrow key or
use the knob to select the desired characters on the virtual keypad, and
then press OK to enter the characters. The input characters are displayed
File Name Input Area Virtual Keypad