User manual

RIGOL Chapter 2 Front Panel Operations
2-14 DP700 User’s Guide
Store and Recall Timer Files
The internal NVM of the DP700 series power supply provides two storage locations
for timer files (Timer1 and Timer2). You can save the edited timing parameters to
the internal memory, or recall the stored timer files to set the timing parameters.
1. Store the timer files
Press Memory to enter the store and recall interface. To save the timer files,
refer to "Store Files".
2. Recall the timer files
Press Memory to enter the store and recall interface. To read the timer files,
refer to "Recall Files". After reading the files, the timing parameters will
make changes, but you can still edit the timing parameters based on your
needs.
Enable the Timing Output
Enabling the timing output will modify the channel output values. Therefore, before
enabling the timing output, ensure that the changes of the channel output will not
affect the devices that are connected to the power supply.
In the timer interface, after setting the parameters for the timer, press On/Off and
select "YES", then the timing output is executed based on the current setting.
 The timer interface displays the actual output status of the channel in real time,
including the actual output voltage, the actual output current, the actual output
power, and the output mode.
 In the timing parameter list, the groups that have been output are grayed out;
the current output group is indicated in yellow; and the groups that have not
been output are indicated in white.
 When "Cycles" is a specified value, after the instrument has completed
outputting operation for a specified number of times (total number of output
groups), the timing output will be terminated. At this time, the state of the
instrument is determined by the "end state" that you have set.
When "Cycles" is set to "Infinite", the instrument makes consecutive outputs
based on the current timer parameter settings. At this time, the end state is
invalid.
Tip
Complete timer parameter settings before enabling the timing output. During the
timing output, the timer parameters are not allowed to be modified.