User manual

Chapter 2 Front Panel Operations RIGOL
DP700 User’s Guide 2-13
 Press the Up/Down arrow key to switch the parameter focus to the
"Output Voltage" line.
 Use the num key or the knob to set a desired value for the output
voltage (the default unit is V). For setting methods, refer to the
descriptions of the help information displayed at the bottom of the
interface or refer to the descriptions in "Parameter Setting
Method".
Note: when the current parameter focus is on the "Output Voltage" line,
press the Left or Right arrow key continuously to switch the parameter
focus to the "Output Voltage" of the neighboring group.
(3) Set the output current
 Press the Up/Down arrow key to switch the parameter focus to the
"Output Current" line.
 Use the num key or the knob to set a desired value for the output
current (the default unit is A). For the setting method, refer to the
description of the help information displayed at the bottom of the
interface or refer to the description in "Parameter Setting Method".
Note: when the current parameter focus is on the "Output Current" line,
press the Left or Right arrow key continuously to switch the parameter
focus to the "Output Current" of the neighboring group.
(4) Set the duration time
 Press the Up/Down arrow key to switch the parameter focus to the
"Duration Time" line.
 Use the num key or the knob to set a desired value for the duration
time (the default unit is s). For setting methods, refer to the
descriptions of the help information displayed at the bottom of the
interface or refer to the descriptions in "Parameter Setting
Method".
Note: when the current parameter focus is on the "Duration Time" line,
press the Left or Right arrow key continuously to switch the parameter
focus to the "Duration Time" of the neighboring group.